Removal Of Shipping Braces; Hs-6040, Hs-6057, Eh090, Eh130 Models - GIRBAU HS-6040 Installation Instructions Manual

Removal of shipping braces

THIS OPERATION MUST BE CARRIED OUT BY THE AUTHORIZED TECHNICAL SERVICE.
DO NOT REMOVE THE SHIPPING RESTRAINTS BEFORE PLACING THE WASHER IN ITS DEFINITIVE
POSITION.
NEVER START THE MACHINE UP WITHOUT FIRST REMOVING THE SHIPPING RESTRAINTS.
INCOMPLIANCE WITH THIS PRECAUTION MAY CAUSE SERIOUS PHYSICAL DAMAGES TO PEOPLE
AND IRREPARABLE DAMAGES TO THE WASHER. THE WARRANTY DOES NOT COVER THIS
INCIDENCE.
TILT MODELS
THE TILT SYSTEM ACCESSORIES MUST BE INSTALLED AFTER HAVING REMOVED THE WASHER
COVERS AND BEFORE REMOVING THE TRANSPORT RESTRAINTS. (Refer to chapter 4)
ONCE THE TRANSPORT RESTRAINTS ARE REMOVED, REPLACE AND PROPERLY LOCKED ALL
WASHER COVERS. NEVER START THE MACHINE UP OR USE IT UNTIL ALL THE COVERS HAVE
BEEN REPLACED AND PROPERLY LOCKED.

2.6.1. HS-6040, HS-6057, EH090, EH130 models


Remove the screws (Fig.2.7/A) holding the lower front
cover and loosen the three screws (Fig. 2.7/B) holding
the base of the chassis.

Separate the rubber profile (Fig. 2.7/C) at the two small
side guards and remove the front cover (Fig. 2.7).

Remove the screws holding the rear cover and remove
it.

Locate on the chassis base the two yellow fixing profiles
and dismantle them. The profiles are secured with
screws (Fig. 2.8)

Assemble the rear cover.

Assemble the front cover and place the rubber profile at
the small side guards.

TILT models. Assemble all the guards of the tilt system
(section 5.7.).
ATTENTION!
The rubber profile is a protection against cutting and
catching. Check that it is properly fixed on the front
cover and side covers.
Transport and location
23
Fig. 2.7
Fig. 2.8
Cod. 511485
Rev.07/0717