Releasing The Security Lock - GIRBAU HS-6040 Installation Instructions Manual

Transporte de la maquina sin embalaje
Unpacking the machine, mainly separating from the wooden base, must be done as closely as possible to the
final location. This way you will avoid damaging the base of the machine as well as the floor.
Once you have separated the wooden base from the
packaging, the easiest way to transport the washers is to
lifting with a crane, using the transport handles as fastening
points which are located at the top of the frame (Fig. 2.4).
To access these fastening points:
 HS-6040, HS-6057, EH090, EH130: Detach the fixing
screws of the two top covers and remove them.
 HS-6110, EH255: Detach the two small covers located
in the top covers, front and centre part of the washer.
The transport handles are visible and accessible.
Once this operation is over, replace and lock the
covers correctly.
When there is no possible way to lift the machines in place by a crane, they must be moved by forklifts or by
means of metallic rollers placed in the base of the washer (attention to the weight of the washers). The length of
these rollers must be 8 in (200 mm) bigger than the base of the washer.

Releasing the security lock

To open the door in case of power failure, completely insert a rod of a
diameter of 0.2 in (3 mm) and an approximate length of 4 in (100 mm) into
the bottom side of the safety lock cover, and at the same time turn the knob
downwards, (Fig. 2.5).
MANUAL OPENING OF THE SAFETY LOCK MUST ONLY BE
USED BEFORE THE START-UP OF THE MACHINE.
ONCE THE WASHER IS IN SERVICE, NEVER USE THE
MANUAL OPENING OF THE LOCK AS A USUAL WAY TO
OPEN THE DOOR.
Transport and location
WARNING!
Fig. 2.5
20
Fig. 2.4
Cod. 511485
Rev.07/0717