Steam Connection In Tilt Models - GIRBAU HS-6040 Installation Instructions Manual

3.4.1. Steam connection in TILT models

ATTENTION!
The end of the steam supply pipe end must be located in the
same vertical plane as the steam inlet (V) of the washing
machine. Otherwise the tilted movements cause torsion
effects that can loosen the threaded couplings.
The value N of Figure 3.10 allows to locate the vertical plane
of the steam inlet regarding to the centre of the washer. Refer
to dimensions in Installation specifications (section 1.4.)
Connection of the machine to the steam installation (Fig.
3.11)
Accessories for the steam connection to TILT washers (some
accessories can be assembled as a single set)
..
A steam inlet filter
..
B threaded coupling
..
C connection flexible pipe. Long.: 59 in. (1500 mm)
..
D threaded coupling
HS models: B and D parts are the same; the thread at
both sides is GAS type.
Threaded coupling D in EH models: assemble part D end
with NPT thread to the steam conduits; the end with GAS
thread must be connected to the flexible pipe C.
Assemble the steam filter A and the coupling B to the
washers steam inlet.
Assemble the threaded coupling D to the steam supply pipe.
Join both couplings by means of flexible hose C. Assemble
the offset end to the washer.
Tighten the flexible pipe connectors firmly.
ATTENTION!
DURING THIS OPERATION, HOLD THE ENDS OF THE
FLEXIBLE PIPE TO PREVENT IT FROM REMAINING
(
TWISTED Fig. 3.12)
Installation
33
Fig. 3.10
Fig. 3.11
Fig. 3.12
Cod. 511485
Rev.07/0717