Pneumatic Actuators Assembly (Figure 4.6); Position Detectors Assembly And Adjustment (Figure 4.8) - GIRBAU HS-6040 Installation Instructions Manual

Pneumatic actuators assembly
The arrow indicates the front of the machine.
The pneumatic actuators, together with the supporting
plates and the beams are delivered mounted in two equal
assemblies A.
Steps to assemble them to the washer:

To determinate the position of each of the two
beams/actuator assemblies, take as a reference the
two pneumatic actuator limit switches B.

Place both assemblies of beams and actuators under
the machine; before doing so, disassemble the two
actuator limit switches B. Before disassembly, note
position of the screws, separators, washers and nuts.

Assemble the beams and the fixed frame. Position of
screws in Figure 4.7. Use both central screws on the
left side to also secure the support plates D of the
electrical installation.

Connect the nylon pipes to the pneumatic fittings E.
The fittings may be oriented to facilitate connection.
Position of mounting screws of the pneumatic actuators
to the fixed frame (side view).
Elements of Figure 4.7.
A: Side of fixed frame
B: Support beams
C: Screw
D: Nut
E: Washers
Important!
The nominal tightening torque of screws M14 is
434lb. in. (5 kg.m.). If this pressure is exceeded
beams may be deformed.
Re-assemble the pneumatic actuator limit switches B
(Figure 4.8).
ATTENTION!
Limit switches are safety devices. Check that they
are properly assembled.
Position detectors assembly and adjustment
(Figure 4.8).
The position detectors A are disassembled to prevent
them from being damaged during transportation. Secure
them to the supports, refer to Figure 4.8. Mounting
screws: M6x15.
Tilt system assembly
(Figure 4.6)
47
Fig. 4.6
Fig. 4.7
Fig. 4.8
Cod. 511485
Rev.07/0717