1.1 Access to the selection switch ....3 above. (Refer to INFO menu, Section 2.4 on the Advanced Operation Instructions rev. 01 at the 2. ACCESS TO CONFIGURATION MENU ..3 www.girbau.com) manufacturer’s website 3. LOGI CONTROL CONFIGURATION ..4 3.1. Heater system ........4 3.2.
CONFIGURATION 1. Disconnect and mechanically lock the external automatic switch. The HS-5008 washing machine has two different 2. Open machine front panel with a key. Refer to modes: the COIN control and the LOGI control. fig. 1. Be careful not to damage or disconnect The operation features and their utility are any control component.
Operation Parameters on the Advanced 2. Press the MOD key to validate the parameter Operation Instructions HS-5008 / H5020 LOGI configuration and to go to the following step. CONTROL rev. 01 at the manufacturer’s website: www.girbau.com.
Consult the contents of the Washing Programs OPTIONS MEANING and the Operation Parameters on the Advanced Operation Instructions HS-5008 / H5020 COIN Ht-0 Unit without heating CONTROL rev. 01 at the manufacturer’s website: Ht-1 Unit with heating www.girbau.com.
Setup 4.4. Payment system 4.7. Inlet 2 (higher value coin) Configuration of parameters related to the Selection of the associated value when inserting programs payment system. coin 2. This parameter is only active if the payment system is configured as dual coin meter When CONF is displayed, press the 1 key four (P-Mo &...
Page 8
COIN CONTROL PSH-0 Advanced Instructions manual. Rev. 01 Section 2.6 SP-0 Hr-0 COIN CONTROL 1,2,3,4, Ncod Access code Advanced Instructions manual. Rev. 01 1,2,3,4. Section 2.7 Refer to www.girbau.com for Advanced Operation Instructions, Logi Control rev. 1 Cod. 409748 Rev. 01/1002...