Direct Connection Of The Washer Drain To The Manifold - GIRBAU HS-6040 Installation Instructions Manual

Installation
26

3.1.2. Direct connection of the washer drain to the manifold

Facilities preferring this option to the open box option (recommended option) must respect the following
precautions:
Provide next to the connection point of each machine to the manifold, with a manifold ventilation outlet A
reaching the outside, set at a height of 60 in. (1500mm) and of a diameter of 2 in. (50mm).
Diameter of B manifold: refer to table on section 2.4 and Figure 2.6.
The emptying of the drain trap to the sewer system is done through an open drain box (Fig. 3.3/B and C) which
prevents variations in pressure and backflow to the drain. The end of the drain trap must not be sunk in the
box.
Fig. 3.3
TILT MODELS
After the starting-up of the washer, check that the loading and unloading movements don't no move
the drain outlet hose out of the sewer drain box.
In installation with the connection directly to the sewer, the connections of both ends of the drain
hose must be fastened.
Cod. 511485
Rev.07/0717