Assembling Tilt System Guards(Figure 4.10) - GIRBAU HS-6040 Installation Instructions Manual

Adjustment of position detectors actuators (Figure 4.9).
The actuators C are secured to the bases through slots
permitting their movement. To adjust their position:

The machine must be in the rest position.

Loosen mounting screws D of actuators C of position
detectors.

Move completely the actuators to the washer's outside
until the microswitch disconnection «click» is heard. The
wheel support lever E will remain in horizontal position.

Move the actuators C towards the position detectors until
the microswitch connection «click» is heard and secure
them in this position. (The contacts change of position is
easily heard).

The actuator must move the lever wheel from the position
detector upwards (refer to figure).

More information in the complementary schematic of
TILT supplement. The schematic shows the machine in
rest position.

Once the position detectors
continue removing the transport restraints, assembling
the covers and installing the machine power supplies
(section 2.5).
Assembling Tilt system guards
The arrow indicates the front of the machine.

Position the rear and front guards. They can be easily
identified as the corners are folded. The rear guard is
distinguished by the drain hose groove.

remove screws, washers and sleeves screwed in the
hinges A from the guards, secured to each of the four
bases. Put the sleeves in the holes at the guards corners.
Secure them using screws and washers. The sleeves
must permit the guards movement. Rectify supports
position if required, by loosing the mounting screws B
and move them in the appropriate direction.

Engage the springs C between the base brackets and the
guards brackets (two springs for each bracket).

Place the side guards between the side brackets and the
folded corners of the front and rear guards.

Place them so that the holes match with the threaded
holes at the side brackets D. Secure them with screws
(M6x10). Fasten it with the screws (M6x10).
ATTENTION!
Never start the machine up or use it until all the covers
have been replaced and properly locked.
Tilt system assembly
actuators adjustment
(Figure 4.10)
48
Fig. 4.9
Fig. 4.10
Cod. 511485
Rev.07/0717