Table of Contents
Advertisement
WAVESHARE ELECTRONICS
Function:
Format:
Query Operation
AT+WSKEYC<CR>
+ok=<auth,encry,key><CR>< LF ><CR>< LF >
Set Operation
AT+ WSKEYC=< auth,encry,key><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
auth: Authentication mode
encry:Encryption algorithm
key: password, ASCII code, shall less than 64 bit and greater than 8bit
This Instruction only effective for WIFI232 works as STA. After WIFI232 module boots up again, the
setting will be effective. But user can set this command when module configured as AP.
5.2.2.2.56
AT+ WSLQ
Function:
Format:
Query Operation
AT+ WSLQ<CR>
+ok=<ret><CR>< LF ><CR>< LF >
Set Operation
AT+ WSLQ< auth,encry,key><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
ret:
should be AT+WSLQ=50<CR>;
Note: if set to 100, the module will not automatically switch WIFI network.If the users only one
STA parameter, please be sure to set this parameter to 100.
6 WIFI232 Usage Introduction
Set/query the third AP„s password of 3 sta parameters settings .
OPEN
SHARED
WPAPSK
NONE: When "auth=OPEN", effective
WEP: When "auth=OPEN" or "SHARED", effective
TKIP: When "auth= WPAPSK", effective
AES:
When "auth= WPAPSK", effective
Set/query the critiacl value of network switching.
The percentage of signal intensity, such as signalstrength was 50%, setting
Page 67 of 81
WIFI232 User Manual
Advertisement
Table of Contents
