Table of Contents
Advertisement
WAVESHARE ELECTRONICS
Function: Set/Query WIFI security parameters as STA;
Format:
Query Operation
AT+WSKEY<CR>
+ok=<auth,encry,key><CR>< LF ><CR>< LF >
Set Operation
AT+ WSKEY=< auth,encry,key><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
auth: Authentication mode
encry:Encryption algorithm
key: password, ASCII code, shall less than 64 bit and greater than 8bit
This Instruction only effective for WIFI232 works as STA. After WIFI232 module boots up again, the
setting will be effective. But user can set this command when module configured as AP.
5.2.2.2.11
AT+WSSSID
Function: Set/Query WIFI target AP SSID parameters as STA.
Format:
Query Operation
AT+WSSSID<CR>
+ok=<ap's ssid><CR>< LF ><CR>< LF >
Set Operation
AT+ WSSSID=<ap's ssid ><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
ap‟s ssid: AP‟s SSID
This Instruction only effective for WIFI232 works as STA. After WIFI232 module boots up again, the
setting will be effective. But user can set this command when module configured as AP.
5.2.2.2.12
AT+ WSLK
Function: Query WiFi link status as STA
Format:
Query Operation
AT+ WSLK<CR>
+ok=<ret><CR>< LF ><CR>< LF >
Parameters:
ret
OPEN
SHARED
WPAPSK
NONE: When "auth=OPEN", effective
WEP: When "auth=OPEN" or "SHARED", effective
TKIP: When "auth= WPAPSK", effective
AES:
When "auth= WPAPSK", effective
"Disconnected", if no WiFi connection;
Page 53 of 81
WIFI232 User Manual
Advertisement
Table of Contents
