Table of Contents
Advertisement
WAVESHARE ELECTRONICS
num: 1~32, default 32. maxima TCP connection;
When configure as TCP/Server, WIFI232 support maxima 32 TCP connections. If not require so much
connection, user can resetting this parameters.
5.2.2.2.27
AT+TCPB
Function: Open/Close TCPB function;
Format:
Query Operation
AT+TCPB<CR>
+ok=<sta><CR>< LF ><CR>< LF >
Set Operation
AT+ TCPB=<on/off><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
sta: TCPB enable status
After WIFI232 module boots up again, the setting will be effective.
5.2.2.2.28
AT+TCPPTB
Function: Set/Query TCPB port number;
Format:
Query Operation
AT+TCPPTB<CR>
+ok=<port><CR>< LF ><CR>< LF >
Set Operation
AT+ TCPB=<port><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
port: decimal ,<65535
After WIFI232 module boots up again, the setting will be effective.
5.2.2.2.29
AT+TCPADDB
Function: Set/Query TCPB server address;
Format:
Query Operation
AT+TCPADDB<CR>
+ok=<add><CR>< LF ><CR>< LF >
Set Operation
AT+ TCPADDB=<add><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
add: TCPB server address, can be IP address or url.
After WIFI232 module boots up again, the setting will be effective
on, TCPB enable
off, TCPB disable
Page 59 of 81
WIFI232 User Manual
Advertisement
Table of Contents
