WAVESHARE ELECTRONICS
Figure 54 Configure Transparent Serial Port Connection (UDP)
Q4: Where to set WIFI232 module network protocol (TCP/UDP)?
WIFI232 network protocol setting see "Application Setting Page" as below Figure,
Protocol: TCP Server
Only Port ID required: 8899 (Default)
Protocol: TCP Client
Application IP address required: it‟s target TCP server „s IP address;
Port ID required: 8899 (Default)
Protocol: UDP
No Server/Client selection required;
Application IP address required: it‟s target device „s IP address;
Figure 55 Module Network Protocols: TCP/Server
Figure 56 Module Network Protocol: TCP/Client
Page 76 of 81
WIFI232 User Manual