Device Management Page; At+Instruction Introduction; Configuration Mode - Waveshare WIFI232 User Manual

WAVESHARE ELECTRONICS
WIFI232 User Manual

5.1.11 Device Management Page

This page use to manage WIFI232 module general setting, such as administrator setting, restart
module button, restore factory default setting button, and update firmware through webpage.
Figure 36 Device Management Page
Restart module button: When you setting the parameters of different web pages,
Notes:
you will click "Apply" button to confirm the setting, but the setting take effect only after
user click the "Restart" button here, the module will re-boot up and refresh the memory
information with new changes.

5.2 AT+instruction Introduction

5.2.1 Configuration Mode

When WIFI232 power up, it will default works as transparent transmission mode, then user can
switch to configuration mode by serial port command. WIFI232 UART default parameters setting
as below figure
Figure 37 WIFI232 Default UART Port Parameters
Page 44 of 81