Table of Contents
Advertisement
WAVESHARE ELECTRONICS
Function: Enable/Disable "Send an ID when module connection is established" function;
Format:
Query Operation
AT+IDFIR<CR>
+ok=<on/off><CR><LF><CR><LF>
Set Operation
AT+IDFIR=<on/off><CR>
+ok<CR><LF><CR><LF>
Parameters:
On/off: Enable or Disable "Send an ID when module connection is established"
function
5.2.2.2.38
AT+IDEVE
Function: Enable/Disable Every time to send data to send ID function;
Format:
Query Operation
AT+IDEVE<CR>
+ok=<on/off><CR><LF><CR><LF>
Set Operation
AT+IDEVE=<on/off><CR>
+ok<CR><LF><CR><LF>
Parameters:
On/off: Enable or Disable Every time to send data to send ID function
Note: The ID function requires that the server carries out corresponding processing.In front of the
data when module connected to the server with two bytes of ID (ID the range is 0 ~ 65535, the
high byte before,
complement.Module is the default ID is 1111, for example, is sent to the server when the first four
bytes "0x57 0x04 0xfb 0xa8".
5.2.2.2.39
AT+AABR
Function: Enable/Disable Self-adaption Baudrate function;
Format:
Query Operation
AT+AABR<CR>
+ok=<on/off><CR><LF><CR><LF>
Set Operation
AT+AABR=<on/off><CR>
+ok<CR><LF><CR><LF>
Parameters:
On/off: Enable or Disable Self-adaption Baudratefunction
On, enable "Send an ID when module connection is established" function;
Off, disable "Send an ID when module connection is established" function;
On, enable Every time to send data to send ID function;
Off, disable Every time to send data to send ID function;
and the low byte behind) plus two bytes ID radix-minus-one
On, enable Self-adaption Baudrate function;
Off, disable Self-adaption Baudrate function;
Page 62 of 81
WIFI232 User Manual
Advertisement
Table of Contents
