Table of Contents
Advertisement
WAVESHARE ELECTRONICS
Set Operation
AT+ WAKEY=< auth,encry,key><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
auth: Authentication mode
encry:Encryption algorithm
key: password, ASCII code, shall less than 64 bit and greater than 8bit;
This Instruction only effective for WIFI232 works as AP. After WIFI232 module boots up again, the
setting will be effective. But user can set this command when module configured as STA.
5.2.2.2.16
AT+HIDESSID
Function: Set/Query hide AP‟s SSID;
Format:
Query Operation
AT+HIDSSID<CR>
+ok=<sta.><CR><LF><CR><LF>
Set Operation
AT+HIDSSID=<sta><CR>
+ok<CR><LF><CR><LF>
Parameters:
When Query,sta reply if module‟s SSID is hide;
When Set,
5.2.2.2.17
AT+MSLP
Function: Set modules into power save mode.(Turn OFF WiFi,
mode or the sta mode)
Format:
Query Operation
AT+ MSLP <CR>
+ok=<sta.><CR>< LF ><CR>< LF >
Set Operation
OPEN
SHARED
WPAPSK
NONE: When "auth=OPEN", effective;
WEP: When "auth=OPEN", effective or "SHARED", effective;
TKIP: When "auth=WPAPSK", effective;
AES:When "auth=WPAPSK", effective;
TKIPAES:When "auth=WPAPSK", effective;
On-not hide SSID
Off- hide SSID
Off-hide SSID
On- not hide SSID
;
Page 55 of 81
WIFI232 User Manual
Regardless of the AP
Advertisement
Table of Contents
