Table of Contents
Advertisement
WAVESHARE ELECTRONICS
time: Range 100 ~10000; Unit: ms. Auto-frame trigger time
5.2.2.2.7 AT+UARTFL
Function: Set/Query UART auto-frame trigger length;
Format:
Query Operation
AT+ UARTFL<CR>
+ok=<len><CR>< LF ><CR>< LF >
Set Operation
AT+ UARTFL=<len ><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
len: Range 64 ~4096; Unit: byte. Auto-frame trigger length;
5.2.2.2.8 AT+TMODE
Function: Set/Query data transmission mode;
Format:
Query Operation
AT+TMODE<CR>
+ok=<tmode><CR>< LF ><CR>< LF >
Set Operation
AT+ TMODE=<tmode><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
tmode: Data transmission mode
After WIFI232 module boots up again, the setting will be effective.
Note: No CMD.After power on, the module will not work in the AT command mode by default.
5.2.2.2.9 AT+WMODE
Function: Set/Query WIFI work mode;
Format:
Query Operation
AT+WMODE<CR>
+ok=<mode><CR>< LF ><CR>< LF >
Set Operation
AT+ WMODE=<mode><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
mode:WIFI work mode
After WIFI232 module boots up again, the setting will be effective.
5.2.2.2.10
AT+WSKEY
Through: Transparent transmission
Agreement: Agreement transmission
Httpdclient
Httpd Client Mode
:
GPIO: GPIO Mode
AP
STA
Page 52 of 81
WIFI232 User Manual
Advertisement
Table of Contents
