Yamaha E60HWD Service Manual page 78

POWR
3. Disconnect the neutral switch connector
2. (WHD)
2
4. Remove the neutral switch bracket 3
(WHD) and bracket 4.
3
NOTE:
Set the shift position to the reverse, when
remove the neutral switch bracket and brack-
et.
5. Disconnect the remote control cables
(remote control model) or throttle cable
5 and shift cable 6 (tiller control cable).
5
5-19
Power unit
69D50170
4
69D50180
6
69D50185
6. Disconnect the battery leads 7 (WHD,
WD), warning indicator leads engine stop
lanyard switch lead (MHD, WHD) and
ground leads 8.
7. Disconnect the starter relay leads 9
(WHD, WD) and coupler 0 from the wire-
harness.
8
9
8. Disconnect the pilot water hose.
9. Remove the shift bracket q.
10. Remove the apron, and then remove the
power unit by removing the bolts.
7
0
69D50190
q
69D5020
69D50210
69D5G11