Checking The Gear Shift Operation - Yamaha E60HWD Service Manual

w
The throttle cable end must be screwed in
a minimum of 8.0 mm (0.31in) a.
5. Install the throttle cable joint 3, clip 2,
and then tighten the lock nut 1.
6. Check that the full advanced screw 8
contacts the stopper 9 when the throttle
grip or remote control lever is fully
opened position.
9
7. Check that the control lever 4 contacts
the crankcase 5 when the throttle grip or
remote control lever is fully closed posi-
tion.
4
8. Check the throttle cable for smooth oper-
ation, if necessary, repeat steps 3-7.
NOTE:
If the remote control cables cannot be prop-
erly adjusted at the engine side, make adjust-
ments at the remote control side.
69D5G11
8
69D30290
5
69D30095

Checking the gear shift operation

1. Check that the gear shift operates
smoothly when shifting it from neutral to
forward or reverse. Adjust the shift cable
if necessary.
2. Set the gear shift to the neutral position.
3. Loosen the locknut 1, remove the clip
2, and then remove the shift cable joint
3.
5
4. Align the set pin with the alignment mark
4 in the center of the shift bracket.
5. Adjust the position of the shift cable joint
until its hole is aligned with the set pin 5.
a
w
The shift cable joint must be screwed in a
minimum of 8.0 mm (0.31 in) a.
6. Install the shift cable joint 3, install the
clip 2, and then tighten the locknut 1.
7. Check the gear shift for smooth operation
and adjust the shift cable length, if nec-
essary, repeat the steps 3-6.
NOTE:
If the remote control cables cannot be prop-
erly adjusted at the engine side, make adjust-
ments at the remote control side.
Control system
1
2
2
3
1
3
4
4
69D30300
5
6
7
6D430226
8
9
3-8