Removing The Hydro Tilt Assembly - Yamaha E60HWD Service Manual

Removing the hydro tilt assembly

1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1.
å
1
∫
1
å S, L-transom models
∫ X-transom model
w
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
2. Remove the tilt pin.
3. Remove the bolts 2 and anode 3.
4. Remove the bolt(s) 4 and spacer 5.
5. Remove the circlip(s) 6 and pin 7.
6. Remove the hydro tilt assembly 8.
å
6
8
5
3
2
69D5G11
∫
8
69D70050
å S, L-transom models
∫ X-transom model
w
69D70060
9 Do not tamper or attempt to open the
hydro tilt assembly.
9 Do not subject the hydro tilt assembly to
an open flame or any other source of
high heat. High heat can cause an explo-
sion due to excessive gas pressure.
9 Do not deform or damage the hydro tilt
assembly in any way. If the hydro tilt
assembly is damaged, damping perfor-
mance will suffer.
7
6
4
69D70220
Clamp brackets, swivel bracket
6
4
3
2
5
7
1
4
2
4
3
69D70225
4
5
6
7
8
9
7-22