Checking The Outboard Motor Mounting Height; Checking The Remote Control Cables (Remote Control Model) - Yamaha E60HWD Service Manual

GEN
INFO
Checking the outboard motor
mounting height
1. Check that the anti-cavitation plate is
aligned with the bottom of the boat. If the
mounting height is too high, cavitation will
occur and propulsion will be reduced.
Also, the engine speed will increase
abnormally and cause the engine to over-
heat. If the mounting height is too low,
water resistance will increase and reduce
engine efficiency.
NOTE:
The optimum mounting height is affected by
the combination of the boat and the outboard
motor. To determine the optimum mounting
height, test run the outboard motor at differ-
ent heights
2. Check that the clamp brackets are
secured with the clamp screws.
1-7 1-
General information
69D10045
Checking the remote control cables
(remote control model)
1. Set the remote control lever to the neutral
position and fully close the throttle lever.
2. Check that the control lever 1 is in its
fully closed position, and check the lever
is contact crankcase 2.
1
3. Check that the shift lever or remote con-
trol lever is in the neutral position, and
check that the center of the set pin 3 is
aligned with the mark a on the shift
bracket.
2
69D10060
F
3
N
a
R
69D30220
69D5G11