ELEC
Checking the fuse (WHD,WD)
1. Check the fuse for continuity. Replace if
there is no continuity.
Checking the starter relay (WHD,
WD)
1. Connect the digital circuit tester leads to
the starter relay terminals.
2. Connect the positive battery terminal to
the brown (Br) lead.
3. Connect the negative battery terminal to
the black (B) lead.
4. Check for continuity between the starter
relay terminals. Replace if there is no
continuity.
5. Check that there is no continuity between
the starter relay terminals after discon-
necting a battery terminal from the brown
or black lead. Replace if there is continu-
ity.
Checking the engine start switch
(WHD)
1. Check the engine start button for conti-
nuity. Replace if there is no continuity.
8-15
Electrical systems
Switch
position
White (W) Black (B)
OFF
ON
START
Checking the neutral switch (WHD)
(WD: if equipped)
1. Check the neutral switch for continuity.
Replace if there is no continuity.
Switch
position
Brown (Br)
Free a
Push b
Checking the choke solenoid (WD)
1. Measure the resistance of the choke
solenoid.
Choke solenoid resistance
(reference data):
Blue (L) — Black (B)
3.4 — 4.0 Ω at 20°C (68°F)
Lead color
Red (R) Yellow (Y) Brown (Br)
Lead color
Brown (Br)
L
B
69D80150
69D5G11