Removing The Flywheel Magnet; Removing The Electrical Components; Removing The Control Levers - Yamaha E60HWD Service Manual

Removing the flywheel magnet

1. Remove the starter pulley, and then
loosen the flywheel magnet nut.
cC
Apply force in the direction of the arrows
shown. While working, do not allow the
flywheel holder to slip off the flywheel.
Flywheel holder: 90890-06522
2. Remove the flywheel magnet.
cC
To prevent damage to the engine or tools,
screw in the flywheel puller set bolts
evenly and completely so that the fly-
wheel puller plate is parallel to the fly-
wheel magnet.
69D5G11
NOTE:
Apply force to the crankshaft end until the fly-
wheel magnet comes off the tapered portion
of the crankshaft.
3. Remove the Woodruff key.

Removing the electrical components

1. Remove the bracket 1, the starter motor
6F650200
2 (WHD, WD models).
2. Remove the base assembly 3, the light-
ing coil 4, and the CDI unit 5.
3. Remove the spark plug caps from the
spark plugs, and then remove the ignition
coils 6.

Removing the control levers

1. Remove the control levers.
6B450090
Flywheel puller: 90890-06521
4
5
1
6
5
Power unit
1
2
3
4
3
5
6
2
7
69D50220
8
9
69D50230
5-20