Checking The Cooling Water Passages; Control System; Adjusting The Start-In-Gear Protection; Synchronizing The Carburetors - Yamaha E60HWD Service Manual

CHK
ADJ
5. Install the thermostat and thermostat
cover, and then tighten the cover bolts.
Checking the cooling water pas-
sages
1. Check the cooling water inlet cover 1,
screw 2 and cooling water inlet for clog-
ging. Clean if necessary.
1
2
2. Place the lower unit in water, then start
the engine.
3. Check for water flow at the cooling water
pilot hole. If there is no water flow, check
the cooling water passage inside the out-
board motor.
3-5
Periodic checks and adjustments
1
69D30060
6F610170

Control system

Adjusting the start-in-gear protec-
tion
1. Set the gear shift to the neutral position.
2. Loosen the bolt 1, and then adjust the
start-in-gear protection cable 2 until the
mark a on the guide, aligns with the
mark b on the stopper.
1
2
3. Tighten the bolt 1.

Synchronizing the carburetors

1. Loosen the throttle stop screw 1 of the
carburetor #2 and push the throttle lever
2 for fully close the throttle valve.
2. Loosen the screw of the carburetor #1
and carburetor #2 by turning the screws
3 clockwise.
NOTE:
The screw 3 is left hand thread.
3
2
4
a
b
69D30070
1
3
69D30080
69D5G11