Electrical System; Starting System - Yamaha E60HWD Service Manual

Electrical system

Symptom: The starter motor does not operate. (WHD, WD)
9 Engine stop lanyard switch is operating normally.

Starting system

Check the fuse for blown.
Is there blown?
No
Check the battery for fully
charged.
Is the battery fully
charged?
Yes
Check the engine start switch
for continuity.
Is there continuity?
Yes
Check the wireharness for
connecting condition and battery
positive lead, terminal, ground
lead bolt for corrosion and loosen.
Are they good
condittion?
Yes
Check the neutral switch for
correctly position or continuity.
Is there
continuity or
correctly
position?
Yes
(continued on following page)
69D5G11
(Refer to page 8-15)
Yes
Replace the fuse.
(Refer to page 1-6)
No Fully charge or replae the fully
charged battery.
(Refer to page 8-15)
No
Replace the engine start switch.
Re-connect or replace the
No
wireharness or lead and replace
or tighten the ground lead bolt.
(Refer to page 3-9)
No
Adjust position or replace the
neutral switch.
Lower unit/Electrical
9-8
1
2
3
4
5
6
7
8
9