Enabling Mac Move - Cisco Catalyst 2960-X Security Configuration Manual

Enabling MAC Move

DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Switch# configure terminal
Step 2 interface interface-id
Example:
Switch# interface gigabitethernet2/0/1
Step 3 switchport mode access
Example:
Switch(config-if)# switchport mode access
Step 4
dot1x max-req count
Example:
Switch(config-if)# dot1x max-req 4
Step 5
end
Example:
Switch(config-if)# end
Enabling MAC Move
MAC move allows an authenticated host to move from one port on the switch to another.
Beginning in privileged EXEC mode, follow these steps to globally enable MAC move on the switch. This
procedure is optional.
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
318
Configuring IEEE 802.1x Port-Based Authentication
Purpose
Enters the global configuration mode.
Specifies the port to be configured, and enter interface
configuration mode.
Sets the port to access mode only if you previously configured
the RADIUS server.
Sets the number of times that the switch restarts the
authentication process before the port changes to the
unauthorized state. The range is 0 to 10; the default is 2.
Returns to privileged EXEC mode.
OL-29048-01