Cisco Catalyst 2960-X Security Configuration Manual page 377

Configuring IEEE 802.1x Port-Based Authentication
Command or Action
Step 4
authentication control-direction {both | in}
Example:
Switch(config-if)# authentication control-direction
both
Step 5 authentication fallback name
Example:
Switch(config-if)# authentication fallback profile1
Step 6 authentication host-mode [multi-auth | multi-domain |
multi-host | single-host]
Example:
Switch(config-if)# authentication host-mode
multi-auth
Step 7
authentication open
Example:
Switch(config-if)# authentication open
Step 8 authentication order [ dot1x | mab ] | {webauth}
Example:
Switch(config-if)# authentication order dot1x
webauth
Step 9 authentication periodic
Example:
Switch(config-if)# authentication periodic
Step 10 authentication port-control {auto | force-authorized |
force-un authorized}
Example:
Switch(config-if)# authentication port-control auto
OL-29048-01
Purpose
(Optional) Configures the port control as
unidirectional or bidirectional.
(Optional) Configures a port to use web authentication
as a fallback method for clients that do not support
802.1x authentication.
(Optional) Sets the authorization manager mode on a
port.
(Optional) Enables or disable open access on a port.
(Optional) Sets the order of authentication methods
used on a port.
(Optional) Enables or disable reauthentication on a
port.
(Optional) Enables manual control of the port
authorization state.
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
Configuring Open1x
353