Enabling Mac Replace - Cisco Catalyst 2960-X Security Configuration Manual

Configuring IEEE 802.1x Port-Based Authentication
SUMMARY STEPS
1. configure terminal
2. authentication mac-move permit
3. end
4. show running-config
5. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Switch# configure terminal
Step 2
authentication mac-move permit
Example:
Switch(config)# authentication mac-move
permit
Step 3
end
Example:
Switch(config)# end
Step 4 show running-config
Example:
Switch# show running-config
Step 5
copy running-config startup-config
Example:
Switch# copy running-config startup-config

Enabling MAC Replace

MAC replace allows a host to replace an authenticated host on a port.
OL-29048-01
Purpose
Enters global configuration mode.
Enables MAC move on the switch. Default is deny.
In Session Aware Networking mode, the default CLI is
access-session mac-move deny. To enable Mac Move in
Session Aware Networking, use the no access-session
mac-move global configuration command.
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
Enabling MAC Replace
319