Applying A Vlan Map To A Vlan - Cisco Catalyst 2960-X Security Configuration Manual

Applying a VLAN Map to a VLAN

Command or Action
Step 7
copy running-config startup-config
Example:
Switch# copy running-config
startup-config
Related Topics
Configuring VLAN Maps, on page 172
Applying a VLAN Map to a VLAN
Beginning in privileged EXEC mode, follow these steps to apply a VLAN map to one or more VLANs:
SUMMARY STEPS
1. enable
2. configure terminal
3. vlan filter mapname vlan-list list
4. end
5. show running-config
6. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Switch> enable
Step 2 configure terminal
Example:
Switch# configure terminal
Step 3 vlan filter mapname vlan-list list
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
176
Purpose
(Optional) Saves your entries in the configuration file.
Purpose
Enables privileged EXEC mode. Enter your password if
prompted.
Enters the global configuration mode.
Applies the VLAN map to one or more VLAN IDs.
Configuring IPv4 ACLs
OL-29048-01