Monitoring Protocol Storm Protection - Cisco Catalyst 2960-X Security Configuration Manual

Monitoring Protocol Storm Protection

Command or Action
Step 2
configure terminal
Example:
Switch# configure terminal
Step 3 psp {arp | dhcp | igmp} pps value
Example:
Switch(config)# psp dhcp pps 35
Step 4 errdisable detect cause psp
Example:
Switch(config)# errdisable detect cause
psp
Step 5 errdisable recovery interval time
Example:
Switch
Step 6 end
Example:
Switch(config)# end
Step 7
show psp config {arp | dhcp | igmp}
Example:
Switch# show psp config dhcp
Monitoring Protocol Storm Protection
Command
show psp config {arp | dhcp | igmp}
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
436
Purpose
Enters the global configuration mode.
Configures protocol storm protection for ARP, IGMP, or DHCP.
For value, specifies the threshold value for the number of packets per
second. If the traffic exceeds this value, protocol storm protection is
enforced. The range is from 5 to 50 packets per second.
(Optional) Enables error-disable detection for protocol storm
protection. If this feature is enabled, the virtual port is error disabled.
If this feature is disabled, the port drops excess packets without error
disabling the port.
(Optional) Configures an auto-recovery time (in seconds) for
error-disabled virtual ports. When a virtual port is error-disabled, the
switch auto-recovers after this time. The range is from 30 to 86400
seconds.
Returns to privileged EXEC mode.
Verifies your entries.
Purpose
Verify your entries.
Configuring Port-Based Traffic Control
OL-29048-01