Preset Points
Where PPT1, PPT2, and PPT3 are indicated, enter the
actual numerical value of the independent variable; Ex-
tension in inches or millimeters; or Strain in either per-
cent, mils, or millimeters.
To obtain a printout of load and energy (refer to the next
section, "Energy") at the preset points, enter the key se-
quence:
The Main Panel Display will show either:
Toggle the [+/–] key until the required display appears.
The printed values are always expressed in the current
operating units.
Note
6-36
[S1] [42] PPT2 [ENTER]
[S1] [43] PPT3 [ENTER]
[S1] [4] [+/–]
SL–4 to suppress printout, or
SL 4 to enable printout.
The key sequence [S1] [4] [+/–] does not dis-
able the Preset Point function of the IEEE-488
supervisory program.
M10-94400-1