Troubleshooting - Bushnell 119599C2 Instruction Manual

TROUBLESHOOTING

"MODEM INIT FAIL" is displayed while taking the test image
If "Modem Init Fail" is displayed, try powering the camera OFF, then
straight to ON. In ON mode, the camera will also attempt to send the
first image when triggered. After first transmitted image is confirmed,
both setup test images and live ON images should function properly.
Camera takes continuous images of no subject
A camera has what is known as a "false trigger" if the PIR sensor thinks
that there is motion and heat in front of the camera lens when there is
no subject in the image. These "False Triggers" are the result of placing
the camera in an environment where there is motion associated with
tree branches creating motion in front of the camera or an area where
there is high heat in the foreground and any motion from wind could
set off the camera. Setting a camera up over water is also a potential
cause for this issue. To remedy this situation:
1. Try moving the camera to an area that does not have any of these
issues or try changing the sensor level on the menu settings.
2. If the camera continues to take images when there is no subject in
them, try placing the camera in an inside environment and aiming
at a location where there is no motion.
3. If the camera continues to show issues, then there is probably an
electronic component issue. If this is the case, please contact our
customer service to send the camera back for repair.
Battery life is shorter than expected
1. Battery life will vary with operating temperature and the number of
images taken over time. Typically, the Aggressor Wireless Cam will
be able to capture several hundred images before the batteries die.
2. Check to make sure you have used new alkaline or lithium batteries.
Bushnell recommends using 12 Energizer
in your Aggressor Wireless Cam to obtain maximum battery life.
Lithium AA batteries
®
51