Bushnell 119599C2 Instruction Manual page 33

Parameter
Video Length
(only affects
video clips in
Video mode)
Interval
Settings
(Bold=default)
10S (second)
default, with 60S
(60 seconds) to 5S
(5 seconds) range
10S (second)
default, with a
60M (minute) to1S
(second) range of
settings available.
(60M-1M are set
in one minute
increments, 59S-1S
are set in one
second increments)
Description
Sets time length of each captured
video clip. Settings begin with 10
second default when parameter is first
selected. After stepping down to 5S,
video length settings start over at 60S.
Note: when IR LED Control setting is
"High" (default), videos at night are
limited to 15 seconds maximum length
to prevent overheating.
Selects the length of time that the
camera will "wait" until it responds
to any additional triggers from the
PIR after an animal is first detected
and remains within the sensor's
range. During this user set "ignore
triggers" interval, the camera will not
capture photos/videos. This prevents
the card from filling up with too
many redundant images. Settings
begin with 10 second default when
parameter is first selected. Note: after
setting down past "1S", settings start
over at "60M".
With Wireless Mode ON, the camera
must complete sending each new image
before the next image can be captured,
so the effective minimum interval will
be approximately 45 seconds.
33