Using The Field Scan Feature - Bushnell 119599C2 Instruction Manual

Be sure to set the current date and time, using the "Set Clock" parameter,
if you choose to change the "Time Stamp" parameter setting to "On" since
that will tell the camera to imprint the date and time on each of the
images it captures.

USING THE FIELD SCAN FEATURE

Field Scan is a useful special feature which allows you to monitor your
food plots or field edges with time lapse images or video. When set to
"On", the Aggressor Wireless Cam will take a photo (or record a video
clip) automatically at your choice of intervals (for example, once every
five minutes) during one or two blocks of time you set up for each
day, without requiring a trigger from an active animal. This has the
advantage of giving you the ability to monitor the edge of a field that
might be 50 or 150 yards away from the camera out of the PIR sensor's
range. The result is an effective range much greater than it would
normally be, with the camera dependant on triggers generated by
nearby animals. This is a great tool for hunters to scout an entire field with
only one camera.
If an animal does enter the area covered by the PIR sensor and generate
a trigger event during a time in between the Field Scan intervals you
set, the camera will capture an image or video just as it normally would,
based on your other menu settings. Here's how to setup and use Field
Scan (be sure you've set the current time in "Set Clock" first, so your Field
Scan recording will stop and start at the correct times of day):
1. Move the main switch to SETUP, then press MENU.
2. Keep pressing the RIGHT key, stepping through the Setup Menu
until you reach Field Scan.
3. Press the UP key to select On, and press OK (Step 1, pg.30). You will
see "A", representing the first block of time you can define (a second
block of time later in the day, "B" can also be setup if you wish). Press
OK (Step 2). This takes you to the screen to set Start and Stop times,
which determines the clock times when the first block of Field Scan
recording will begin and end for each day. You can set these times
to the exact hour and minute you want, for a recording "window"
that lasts anywhere from just a minute to a full 24 hours.
27