Bushnell 119599C2 Instruction Manual page 29

These settings would cause the camera to capture a photo (or video, if
the camera is set to that mode) once every 15 minutes, beginning at 6
AM, until the Field Scan "A" recording block stops at 8:00 AM. Later that
day, the camera would again take a photo or video every 15 minutes
between 5:30 PM and 7:00 PM (during Field Scan time block "B"). The
next day, the camera would again record an image or video once every
15 minutes between 6:00 and 8:00 AM, and between 5:30 and 7:00 PM.
No Field Scan recording would occur from 8AM to 5:30PM, or from 7PM
to 6AM. Remember, Field Scan recording is independent of normal
triggers due to animal activity–even if no animals enter the IR sensor
coverage zone, an image or video will still be captured every 15 minutes
during the block(s) of time. If an animal triggers the camera "in between"
the 15 minute intervals, it will be recorded, same as it would if you had
setup the camera with Field Scan turned Off. Note: Field Scan settings
of frequent intervals and/or long periods between start and stop time
can reduce battery life.
29