Bushnell 119599C2 Instruction Manual page 52

TROUBLESHOOTING
3. Make sure that the power switch was turned to the "On" position
and that the camera was not left in "Setup" mode while in the field.
4. Make sure that you are using a good quality name brand SD card
in your camera. Bushnell recommends SanDisk
up to 32GB (Ultra
indicates that poor quality SD cards can sometimes reduce your
Aggressor Wireless Cam battery life.
Camera stops taking images or won't take images
1. Please make sure that the SD card is not full. If the card is full, the
camera will stop taking images.
2. Check the batteries to make sure that they are new alkaline or
lithium AA batteries. See previous notes about short battery life.
3. Make sure that the camera power switch is in the "On" position and
not in the "Off" or "Setup" modes.
4. Make sure that you are using a good quality SD card in your camera.
Bushnell recommends SanDisk ® SD Cards up to 32GB (Ultra
Extreme
5. If the SD card has its write protect switch in the lock position, the
camera will not take images.
6. If you have used an SD card in another device before inserting it in
your Aggressor Wireless Cam, you might want to try formatting
the card using the "Format" parameter in Setup mode (make sure
you have backed up any important files first, as formatting will
erase all previous files). In some cases, other devices may change
the formatting of the SD card so that it will not work properly with
the Aggressor Wireless Cam.
Camera won't power up
1. Make sure that you have installed all twelve batteries in the battery
compartment, filling all 12 battery spaces with no "gaps"
Bushnell recommends using 12 Energizer ® Lithium AA batteries
in your Aggressor Wireless Cam.
2. Make sure that the batteries are installed correctly, observing
proper polarity. Always place the negative (flat) end of each battery
in contact with the spring side of its slot inside the camera.
52
or Extreme
®
series for HD video) .
®
series for HD video). Our experience
®
brand SD Cards
®
®
.
or