Bushnell 119599C2 Instruction Manual page 55

TROUBLESHOOTING
4. Try to avoid setting the camera up on small trees that are prone to
being moved by strong winds.
5. Remove any limbs which are right in front of the camera lens.
PIR Sensor LED Flashes/Doesn't Flash
1. When the camera is in the "Setup" mode, a special LED on the front
of the camera will flash when it senses motion. This is for setup
purposes only and will help the user aim the camera.
2. During use, the LED will not flash when the camera takes an image.
This is to help keep the camera hidden from game.
LCD Screen Issues
1. LCD screen powers on but no text is present.
a. After moving the switch from "Off" to "Setup" or "On", make
sure that the switch is correctly in position to ensure the proper
mode (avoid positions "between" two modes).
b. Do not move the switch directly from "On" to "Setup"-always
move the switch all the way down to "Off" first, then back up to
"Setup".
2. Screen comes on but then powers off
a. Make sure that you have installed the SD card correctly.
Camera won't retain settings
Make sure that you have been saving the changes to any parameter
settings that you made while in Setup mode, by pressing "OK"
after changing the setting. If you don't save your new setting after
changing it, the camera will continue to use the original default
setting for that parameter.
Moisture or Ants Inside Camera
1. To ensure humidity or rain is kept out of the camera, secure the DC
In plug firmly in place.
2. Ants can be attracted by low level electronic vibrations, and enter
through any gaps between the exterior and interior of the camera.
Make sure the DC In plug is securely attached.
55