Bushnell 119599C2 Instruction Manual page 54

TROUBLESHOOTING
5. Photos with streaked subject
a. In some cases with low lighting conditions and fast moving
subjects, the 8MP or 14MP resolution settings may not perform as
well as the 3MP setting.
b. If you have multiple images where fast moving subjects produce
streaks on the photo, try the 3MP setting instead.
c. Set "NV Shutter" to "High" to minimize motion blur.
6. Red, green or blue color cast
a. Under certain lighting conditions, the sensor can become
confused resulting in poor color images.
b. If this is seen on a consistent basis, then the sensor may need
servicing. Please contact Bushnell customer service.
7. Short video clips—not recording to the length set
a. Check to make sure that the SD card is not full.
b. Make sure that the camera has good batteries in it. Near the end
of the battery life, the camera may choose to record shorter video
clips to conserve power.
c. When LED Control is set to "High" and camera is in Video mode,
the maximum available video length at night is 15 seconds to avoid
potential overheating of batteries and/or electronic components.
Date/Time Stamp not appearing on images
1. Make sure that the "Time Stamp" parameter is set to "On".
Photos Do Not Capture Subject of Interest
1. Check the "Sensor Level" (PIR sensitivity) parameter setting. For
warm temperature conditions, set the Sensor Level to "High" and
for cold weather use, set the sensor for "Low". For variable weather,
use "Auto".
2. Try to set your camera up in an area where there is not a heat source
in the camera's line of sight.
3. In some cases, setting the camera near water will make the camera
take images with no subject in them. Try aiming the camera over
ground.
54