Table of Contents
Advertisement
TROUBLESHOOTING / FAQ
Camera takes continuous images of no subject
A camera has what is known as a "false trigger" if the PIR sensor thinks that there
is motion and heat in front of the camera lens when there is no subject in the image.
These "False Triggers" are the result of placing the camera in an environment
where there is motion associated with tree branches creating motion in front of the
camera or an area where there is high heat in the foreground and any motion from
wind could set off the camera. Setting a camera up over water is also a potential
cause for this issue. To remedy this situation:
1. Try moving the camera to an area that does not have any of these issues or try
changing the sensor level on the menu settings.
2. If the camera continues to take images when there is no subject in them, try
placing the camera in an inside environment and aiming at a location where
there is no motion.
3. If the camera continues to show issues, then there is probably an
electronic component issue. If this is the case, please contact our
customer service to send the camera back for repair.
Battery life is shorter than expected
1. Battery life will vary with operating temperature and the number of images
taken over time. Setting the Interval time to 1 second will decrease battery
life. Typically, the Trophy Cam HD Aggressor will be able to capture several
thousand images before the batteries die.
2. Check to make sure you have used new alkaline or lithium batteries. Bushnell
recommends using a full set of Energizer
Trophy Cam HD Aggressor model to obtain maximum battery life.
3. Make sure that the power switch was turned to the "On" position and that the
camera was not left in "Setup" mode while in the field.
4. Make sure that you are using a good quality name brand SD card in your camera.
Bushnell recommends SanDisk
Extreme
series for HD video). Our experience indicates that poor quality SD
®
cards can sometimes reduce your Trophy Cam HD Aggressor battery life.
Camera stops taking images or won't take images
1. Please make sure that the SD card is not full. If the card is full, the camera will
stop taking images.
Lithium AA batteries in your
®
brand SD Cards up to 32GB (Ultra
®
or
®
31
Advertisement
Table of Contents
