Bushnell 119599C2 Instruction Manual page 28

4. Set the [Start] and [Stop] times, beginning with the Start hour, using
the UP/DOWN keys to change the setting (Step 3). The hour setting
is based on a 24-hour clock, with "00" hours = midnight, "12" hours
= noon, "23" hrs = 11PM, etc. To move to the next setting, press the
RIGHT key, change the minute for the Start time with UP/DOWN,
then on to the hour and minute settings for the Stop time.
5. After you finish setting the Stop minutes, press OK to confirm your
settings for the first block of Field Scan recording. If desired, you can
create a second block of time by pressing the DOWN key to select
"B" (Step 4), then press OK and follow the same process to set Start
and Stop times for Field Scan block "B" (Step 5). As an example of how
you might use these two available time blocks, you could setup
Field Scan time block "A" for the dawn hours from 6 AM to 8 AM, and
block "B" to capture images between 5:30 and 7 PM. No Field Scan
recording would occur from 8 AM to 5:30 PM, or from 7 PM to 6 AM.
6. After setting Start/Stop times to define Field Scan block "A" and/or
"B", press OK, then press the UP or DOWN key to select "Interval"
and press OK (Step 6). The Field Scan "Interval" setting lets you control
how often a photo or video clip is recorded during the block(s) of
time you defined with the Start and Stop settings. Your options
are 60 minutes, 30 minutes, 15 minutes, or 5 minutes (this is the
default)
OK to save it (Step 7). Note that for videos, "Interval" is independent of the
Length of each video recording-it's how often videos are recorded, not
how long each one lasts.
7. Here's an example of how the camera would operate, based on the
following Field Scan settings:
28
. Use the UP/DOWN keys to select your preference, then press
Field Scan: On
Field Scan A:
[Start]: 6:00
[Stop]: 8:00
Field Scan B:
[Start]: 17:30
[Stop]: 19:00
Interval: 15M
Note: avoid any "overlap" of Field Scan A & B recording
blocks when setting their start and stop times, to
assure correct operation. Start & Stop times must
be in order, within the same day.
If the "Camera Mode" menu parameter is set to "Day"
or "Night" operation only, that will take priority over
your Field Scan settings. Set the Camera Model to "24
HR" if you are setting both day and night start and/or
stop times in Field Scan.