Isib (8=Isib); Additional System Parameters (9=Parm) - Notifier 1010 Installation And Programming Manual

1010/2020 I A
NSTALLATION ND

ISIB (8=ISIB)

Option 8 allows the changing of any of the following:
Intelligent SIB
ANN
XINT
UDACT
A S
DDITIONAL YSTEM
This option allows the programmer to de-activate/activate the following:
High Day/Night Zone
Low Day/night Zone
Detector Verification
Counter
SACM/SAQM Reporting
Drift Compensation
Pager Programming
Modem Programming
NAM Programming
Rapid Polling
ACS Reporting
P M
ROGRAMMING ANUAL
Allows you to add or delete the ISIB and set the network address.
Add or Delete Annunciators Boards.
When activated allows Upload/Download through Verifire. This will
disconnect the Annunciators RS485 stream to be dedicated to
UP/DL. Repeat to return too normal once UP/DL complete.
Not Used in Australia.
P (9=PARM)
ARAMETERS
Allows you to set detector sensitivity for High see Note below *.
Allows you to set detector sensitivity for Low see Note below *.
This option resets the counter that records the number times a
detector went into AVF without alarming.
Not Used In Australia.
When selected the Panel automatically adjusts the detectors to
the environmental condition of the surroundings, within certain
parameters, see Note below **.
Activate if Pager Interface installed.
Activate if Modem installed.
Activate if Network Annunciator Module installed.
Sets first 20 modules on each loop to poll at double the rate,
providing faster response. (ie: Manual Call Points, Bell Outputs)
If activated Any input module with a supervisory type ID, will
indicate state changes on an Annunciator as a red LED.
C
OPYRIGHT
© 2000, N I P
OTIFIER NERTIA TY
L
TD
P 41
AGE