Rogramming Ustom Essages - Notifier 1010 Installation And Programming Manual

1010/2020 I A
NSTALLATION ND
P C
ROGRAMMING USTOM
Once in Program mode, the LCD-80 ceases all communication on the RS-485 and waits for
commands from the RS-232 circuit. The LCD-80 screen will display:
Configure the Laptop in Terminal Mode, and it will display:
Any one of the nine custom messages may be programmed by pressing the respective number
followed by ENTER on the keyboard. The LCD-80 screen and the display monitor will display either
a default message or whatever message was last stored in the unit. Text cannot be immediately
entered since the cursor starts at the end of the message. The LCD-80 programmer must edit the
message using the backspace key, then enter a new message.
Once the message has been edited, press the ENTER key to store the message.
The screen will return to the display,
These custom messages have various character widths and are displayed under different conditions
present within the fire alarm system.
Number
Message Conditions under which each message will be displayed
Number
1 Standard display banner for the LCD-80.
2 Displayed under Normal conditions
3 Displayed when communications between LCD-80 and the control panel have
been interrupted.
4 Displayed under all Alarm conditions.
5 Displayed under all Fault conditions.
6
7
Messages 6 through 9 are not displayed on the LCD-80.
8 These messages are sent to a printer connected to the LCD-80.
9
P M
ROGRAMMING ANUAL
M
ESSAGES
READY FOR PROGRAMMING
ENTER 1 to 9 FOR 9 CUSTOM MESSAGES
OR 0 FOR CUSTOM POINT LABEL:
READY FOR PROGRAMMING.
C
OPYRIGHT
© 2000, N I P
OTIFIER NERTIA TY
L
TD
P 21
AGE