Cooperative Control -B Y -Event (6=Ccbe) - Notifier 1010 Installation And Programming Manual

P 48
AGE
NOTE:
Each detector, module or zone may only be mapped to one Annunciator point. Therefore, if it is
desired to map one detector to more than one Annunciator point or to map a group of detectors,
modules or zones, to more than one Annunciator point; then this can be achieved by mapping them
to a dummy zone and the dummy zone can then be mapped to an Annunciator point. This is for
annunciation purposes only.
If control is desired from both Annunciators, then the shadow Annunciator Function must be used.
For Annunciator point mapping information on a 1010/2020 with NOTI•FIRE•NET, Contact:
Notifier/Inertia Fire systems for further information.
C C
OOPERATIVE ONTROL
Option 6 of the Partial Point Programming Menu allows the programmer to change the Cooperative
Control-By-Event (CCBE) for any reverse activated zone when using the 1010/2020 with the
NOTI•FIRE•NET. (Contact Factory for NOTI•FIRE•NET Manual)
Full Point Programming (4=FPRG)
Option 4 from the Programming Menu allows the programmer to completely program all the
Addressable detectors, modules, software-defined zones and Annunciator points in the 1010/2020
system. The programming examples illustrate the screen prompts displayed during Full Point
Programming.
A full point program performs all the functions of partial point above sequentially.
Full point programming must be used when changing a type-id due to a hardware change. IE:
Control module becomes an input module, Photo-optical becomes a Thermal etc.
NOTE: The control panel continuously loops back through the Full Point Programming routine,
allowing the programmer to enter devices, software zones or Annunciator points one after
the other. Use the Backspace key to exit Full Point Programming.
-B -E (6=CCBE)
Y VENT
C © 2000, N
OPYRIGHT
1010/2020 I
I P L
OTIFIER NERTIA TY TD
A P
NSTALLATION ND ROGRAMMING
M
ANUAL