Notifier 1010 Installation And Programming Manual page 49

1010/2020 I A
NSTALLATION ND
Example: Full point program on an analog Photo-optical detector at L2D23.
The Photo-optical Smoke Detector on Loop 2 will be programmed to activate two software zones
(Z13, Z29) and a control module (L2M19), and also be mapped to Annunciator address "02"
Point "02".
Select 4 from the Main Programming Menu for Full Point Program.
ENTER LXX(D/M)YY, ZXXX OR AXXPYY FOR PT INSTALL
(BCKSPC TO ABORT)
ENTER TYPE ID
ENTER CONTROL-BY-EVENT
ENTER 20 CHARACTER CUSTOM LABEL.
IS THE DETECTOR VERIFICATION OPTN TO BE ENABLED
FOR THIS DEVICE?(Y=YES,N=NO)
ENTER THE DETECTOR SENSITIVITY SELECTION FOR THIS
DEVICE (L=LOW,M=MED,H=HIGH)
IS THE TRACKING OPTION TO BE ENABLED FOR THIS
DEVICE? (Y=YES,N=NO)
IS THERE DAY/NIGHT SENSITIVITY CONTROL FOR THIS
DEVICE? (Y=YES,N=NO)
DO YOU WANT THIS POINT MAPPED TO AN ANNUNCIATOR?
(Y=YES,N=NO)
ENTER AXXPYY FOR Annunciator POINT MAPPING
Example: Programming Annunciator Points
Installation of individual Annunciator points.
ENTER LXX(D/M)YY, ZXXX OR AXXPYY FOR PT INSTALL
(BCKSPC TO ABORT)
ENTER TYPE ID
P M
ROGRAMMING ANUAL
C
OPYRIGHT
© 2000, N I P
OTIFIER NERTIA TY
L2D23
PHOT
(Z13 Z29 L2M19)
MAIN LOBBY DETECTOR
Y
H
Y
Y
Y
A2P2
A2P2
AINP
L
TD
P 49
AGE