Performing Cryotherapy - Zimmer Cryo 6 Instructions For Use Manual

Operation instructions

9.2 Performing cryotherapy

Switching device on Switch on the device at the mains switch (10), display lights up.
Initialisation The current status (self-test, pre-cooling) can be read off at the display during
initialisation.
The factory settings mean that the start-up screen and start-up process are different
Note:
depending on whether you are using the device with the Cryo 6 Physio or Cryo 6
Derma pre-set parameters.
See the next page for illustrations of both start-up screens.
Selection The device is ready to use as soon as the treatment screen (in this case "Physio")
Program and treatment appears.
time
Use the program selection keys (14 and 15) to set the desired treatment program
and the timer keys (16 and 17) to set the desired treatment time.
Note: The fan level cannot be altered before the start of treatment.
Start of treatment Press the start/stop (18) key to start the program running.
The fan level (14 and 15) and treatment time (16 and 17) can be altered by pressing
the corresponding keys during treatment.
Note: If parameters are altered during treatment, the factory settings are restored after the
end of treatment (or the favourite program settings if a favourite program has been
stored).
End of treatment An acoustic signal indicates the end of treatment, and the fan is automatically
switched off. This also applies to premature interruption of treatment via the
start/stop key (18).
7
P2
OK
P P
7
OK
10:00
Start/ Stop
05:30
Start/ Stop
Page 22
9