Device Set-Up; Fitting - Zimmer Cryo 6 Instructions For Use Manual

Device set-up

7.1 Fitting

Cryo 6 must be placed upright and kept in an upright position for at least 30 minutes
!
Caution
before being switched on if the device has been transported on its side or had fitting
work done on it.
Otherwise the compressor could be damaged.
Connect power cable Connect the power cable to the provided port (11) on the device and connect the
cable to the mains.
Note: The device may only be connected to power outlets with a protective contact
Switching device on The device is switched on using the toggle switch (10).
Switching device off The device is switched off using the toggle switch (10).
To fully (all poles) disconnect the device from the mains, the power cable must be
disconnected.
All cables must be protected from pinching or other mechanical damage.
!
Caution
Fitting the treatment Insert the treatment tube into the connector (5) on the front of the device and lock it
tube into place.
The treatment tube can be stored in the curved groove above the control panel (3)
when not in use.
Fitting the castor Attach the castor guards (2) to the wheel holders.
guards
Fitting the glass plate Four spacing bolts are already fitted to the top of the device to allow the glass plate
to be attached.
Place a silicon intermediate disc onto each of the four spacing bolts.
Then put the glass plate on the spacing bolts.
Now secure the glass plate by screwing one of the clamp bearings provided into
each of the four spacing bolts.
You do not need to use a tool for this, in order to prevent damage to the glass plate.
Use your fingers to tighten the clamp bearings.
7
Page 9