Own Programs And Favourites - Zimmer Cryo 6 Instructions For Use Manual

Settings

8.5 Own programs and favourites

Note: The "Internal programs", "Programming of 1 and 2-phase programs" and "Favourite
program" can only be activated if "Programs" is activated as the start-up process
(see point. 8.2).
Own programs Cryo 6 offers storage options for three own programs in addition to the six factory
pre-set programs which cannot be permanently changed.
Fan level and time can be allocated individually to a storage location.
The programs can be programmed either for one phase or for two consecutive
phases.
Programming a Use the arrows (14 and 15) to navigate among the three storage locations.
1-phase program Press the "Select" key (17) to select the stored program that you want to use.
You can then use the arrows (15 and 16) to select the desired fan level. The fan
symbol (20) flashes.
Press the "Save" key to save the fan level.
The fan symbol now stays lit and the time symbol (22) flashes.
Use the arrows (14 and 15) to select the desired time.
Press the "Save" key to save the time.
Activate the "Back" key to stop programming the 1-phase program. Press the "Back"
key to quit the menu.
Programming a Here you can arrange for two programs with different fan levels and times to run
2-phase program consecutively in a single treatment session.
Start in the same way as when programming a 1-phase program. Now, instead of
pressing the "Back" key to quit the program, press the "Save" key again. The
parameters for phase 1 now appear in small font at the top of the display.
Favourite Here you can select a personal favourite program that is automatically loaded
whenever the device is started up. You can choose one of the six factory pre-set
programs P1-P6 or one of the own special programs S1-S3. Use the arrows (14 and
15) to navigate among the program locations. Choose the program you want to
define as the favourite and press the "Select" key to confirm.
8
Page 19