Table of Contents
Advertisement
Device set-up
7.2 Fitting the supporting arm
Fitting instructions
The glass plate must be attached to the device so that a supporting arm can be fitted
(see 7.1 Fitting) The glass plate contains an opening through which the supporting
arm passes.
The glass plate can be fitted so that it is symmetrical with the device. If a supporting
Note:
arm is also fitted, the glass plate is laid on the spacing bolts in such a way that the
hole for positioning the supporting arm is on the correct side of the device.
Step 1 - fitting the guide sleeve
Assemble the guide sleeve (supplied with the glass plate) in the hole made for this
purpose.
Step 2 - fitting the supporting arm securing element
Use the Allen key and the M6x16 screws to screw the mounting bracket to the base
of the device.
Threaded holes are already in place on the base of the device for this purpose.
The view from below is only presented for clarification, please DO NOT put the
!
Caution
device down for fitting!
Guide sleeve
Part 1
Guide sleeve
Part 2
7
Threaded
holes
Page 12
Hide quick links:
Advertisement
Table of Contents
