Structure Of A Machining Program Db In The Pc Memory - Siemens SIMATIC S5 Manual
Positioning module
1p 247
for stepper motors
Hide thumbs
Also See for SIMATIC S5:
- Manual (396 pages) ,
- Equipment manual (197 pages) ,
- Operating instructions manual (43 pages)
Table of Contents
Advertisement
Parameters requiring two words, e.g. zero offset, are 32-bit fixed point numbers. Negative values
are stored as 32-bit fixed point numbers in 2's complement. When the value is input or inter-
preted, remember that the programmer does not make any suitable format available for this.
The machine data can
6.3.8.2
Structure of a Machining Program DB in the PC Memory
BA = 22
BA = 23
BA = 69
The structure and syntax of machining programs is explained in Section 2.6 "Machining Pro-
grams and their Structure".
be transferred, read or deleted via the axis interface (parameter
only
machining programs transferred from PC to IP247,
machining programs deleted on the IP247,
machining programs read from the IP247.
Standard Functjon Block FB165
6-41
Advertisement
Table of Contents
