Siemens SIMATIC S5 Manual page 175

Input
— — ————
I — . — — — —
Fig. 5/1 6 Machining program display according to DIN
Description of the output fields
The header is as described in the section "Generating Machining Programs,
The program type
comments are output in the output field PROG HEADER.
Description of the input fields
You enter the statements of the machining program in the individual lines. Once you reach the
last line, the machining program is scrolled one line upwards, i.e. a new page is begun. The pre-
vious page is displayed again if you press <F2>.
Significance of the function keys
<Fl >: This function key is used to page forwards when the machining program is longer than
one page and when you are not on the last page. -
5 - 3 8
— _ _ — _ . _ _ _ .
. . . = input field
for main program or "L" for subroutine), the program number and any
BLOCK : DB II=j
: —
D E V I C E
_ . _ _ . — _ — — . — — — — . ————
—
field