Siemens SIMATIC S5 Manual page 168

The following information is supplied in the header:
the machine data are for a linear axis,
source
the device (FD, PG or IP247) from which they were read,
the DB number under which they are stored,
the axis and module for which they are intended and
the measuring system (mm, in or deg.) of the machine data.
The footer is explained in the machine data printout display.
. — — —
MACHINE DATA
— — — —
Fig. 5/1 3 Machine data printout display
In this display there are two lines available to enter information about the machine data, e.g. the
plant for which they are intended etc. This information is only used for documentation (here,
PRINTOUT MACHINE DATA AXIS 1), The fields in the third line, "plant designation" and
"generated by" are completed automatically from the information in the presets display. The date
can also be entered. The page number is incremented automatically following each formfeed.
Siemens AG°C79000-B8576 -C707-01
— .
— — .
Printer type
Lines per page (40-95)
Columns per line (80-132) :
BLOCK
DEVICE :~<fi 1
—
1
—
r : =
field
:
5-31