Installation; Preliminaryrequirements - Siemens SIMATIC S5 Manual

Zero offset 3
Zero offset 4
You can only activate these zero offsets in the machining program (=> Part 4 "Functions").
7.1.5

Installation

PreliminaryRequirements

7.1.5.1
The programmable controller is correctly configured. The power supply has been connected ac-
cording to the regulations (=> manual of the programmable controller).
Note
If a spindle or similar device is to be driven by the motor, all the limit switches must
be connected.
There must bean emergency stop switch to switch off the whole
equipment.
Two limit switches signaling directly to the module. Here you can use
either normally open or normally closed contacts.
Two normally closed contacts as limit switches, outside the limit
switches mentioned above which either switch off the power unit
directly or suppress the input pulse train of the power unit.
You also require the following:
A programmer, PG 635, PG 675, PG685, PG695, PG730 or PG750 with the S5-DOS operat-
ing system
The COM247 communications software for your PG
Planning
o
ok
o
ok
o
ok
7 - 9